Referral service: we connect you with independent, vetted local foundation contractors who do the work. How it works & how we're paid

Guide · Updated Nov 20, 2026

Foundation elevation survey: what it measures and how much movement is acceptable

A surveyor in a hard hat and high-visibility vest reading an optical dumpy level on a tripod in an open field
A surveyor taking readings with an optical level on a tripod. Illustrative only, not a San Antonio home or a partner's project. Photo: LP B, Oxford Archaeology, CC BY 4.0.

"Your floor is out of level" means nothing without numbers. A foundation elevation survey turns the house into a map of relative floor heights, and the Foundation Performance Association's guideline gives engineers two yardsticks to judge it: a deflection limit of L/360 and a tilt limit of 1% (FPA-SC-13-1). Here's what that means for your house.

The story: two inches that didn't matter, and half an inch that did

Picture this (a typical scenario, not a real customer). One family hears their slab is "2 inches out" and panics. Their survey shows the whole slab leaning gently one way, with no cracks to match. Their neighbor's house is only half an inch off, but the dip sits in the middle of a 20-foot wall with a diagonal crack over the door. The second house is the one that needs a closer look, because bending, not leaning, is what cracks walls.

What the survey actually measures

An engineer typically uses an electronic digital level or a survey laser level to record elevations throughout the house, then plots them as a contour map over the floor plan (FPA homebuyer guide). FPA-SC-13-1 says the equipment should read to a precision of 1/8 inch or better (accuracy of ±1/16 inch or less), and that a carpenter's level is useful for countertops and door frames but not enough to build an elevation plan (FPA-SC-13-1).

Readings are taken relative to a reference point, ideally near the center of the house, because the center of a foundation is generally less susceptible to movement. Its location goes on the floor plan so a later survey can reuse it (FPA-SC-13-1).

The two limits: deflection and tilt

  • Deflection (bending): FPA-SC-13-1 sets the limit at L/360, the span length divided by 360 (FPA-SC-13-1). Worked example (our math): over a 30-foot span, 30 × 12 ÷ 360 = 1 inch; over 20 feet it's about 2/3 inch.
  • Tilt (leaning): no more than 1.0% over the entire length, width or diagonal. The FPA notes tilt doesn't create bending stress in the foundation, though too much can affect how the building functions (FPA-SC-13-1).

Two cautions from the guideline itself: the limits only apply if the data is collected and analyzed its way, and new foundations are rarely level. It says an overall levelness tolerance of 1.5 inches (±0.75 inch) is widely considered acceptable for slab construction, and most residential slabs are built within 1.0 inch of level (FPA-SC-13-1). So a single "out of level" number can be partly how the slab was poured.

Levels of investigation (what you're paying for)

LevelWhat it includesTypical use
Level AInterview plus a visual walk-through; observations onlyTypical real estate inspections
Level BAdds relative elevation readings on a scaled drawing, contours or cross sections, and deflection/tilt checksNeeded to apply the FPA's movement limits
Level CAdds testing the engineer deems appropriate (soil borings, hydrostatic plumbing test, coring and more)Disputes and complex causes; supervised by a forensic engineer

Source: Foundation Performance Association, FPA-SC-13-1: Guidelines for the Evaluation of Foundation Movement for Residential and Other Low-Rise Buildings (Rev. 1, Apr 11, 2015; PDF), Section 3.

What it costs

Elevation readings are usually part of a foundation inspection. Angi's 2026 national average for a foundation inspection is $600, with most homeowners paying $300–$3,000 (Angi). HomeGuide lists a structural engineer foundation inspection at $300–$750 (HomeGuide). See foundation inspection cost for the breakdown.

Why a baseline survey is worth keeping

The FPA recommends that buyers get a baseline elevation survey, which can be useful if movement happens later (FPA-SC-13-1), and its homebuyer guide says a second survey six to twelve months later can show whether movement is ongoing (FPA). In San Antonio clay, compare readings from late summer and late winter rather than a single day; see San Antonio expansive clay soil.

Do a quick screen first

Before paying for a survey, try the FPA's homeowner screen: more than 1/4 inch of slope over four feet with a carpenter's level may indicate abnormal movement (FPA). Our floor slope calculator converts your reading. Then read the 20-point inspection checklist and what happens at a foundation inspection.

Questions to ask whoever does the survey

  1. What equipment will you use, and what's its stated accuracy?
  2. Where is the reference point, and will it be marked on the plan?
  3. Will I get the elevation plan and contour map in writing?
  4. Will you check deflection and tilt against FPA-SC-13-1, and over which spans?
  5. If repairs are recommended, is a Texas-licensed engineer involved? (San Antonio requires one for permitted foundation repair: permit guide.)

Your offer: a free inspection with real readings

Want numbers instead of guesses? LevelSATX Foundation Network matches you with one vetted, independent network partner for a free foundation inspection and a written quote if work is needed. Ask them to include floor elevation readings. We are a referral service and don't do repairs; partners pay us for referrals, and any company can apply to join the network.

Get my free inspection match

Want a real number for your home?

Calculators and guides give ranges. A free inspection from one vetted, independent local contractor gives you a written quote. No cost, no obligation.

Get my free inspection →

Or call (210) 796-7891.

Frequently asked questions

What is a foundation elevation survey?

It is a set of relative floor-height readings taken across the house with a digital or laser level, usually plotted as a contour map on the floor plan. The Foundation Performance Association's homebuyer guide calls it a snapshot of the foundation's levelness at the time it is taken.

How much foundation movement is acceptable?

For slab foundations, the FPA's FPA-SC-13-1 guideline proposes a deflection limit of L/360 (the span length divided by 360) and a tilt limit of 1 percent over the full length, width or diagonal. Those limits only apply when the data is collected and analyzed the way the guideline describes.

Is a slab supposed to be perfectly level?

No. FPA-SC-13-1 notes that new foundations are rarely level, that an overall levelness tolerance of 1.5 inches (plus or minus 0.75 inch) is widely considered acceptable for slab construction, and that the committee found most residential slabs are built within 1.0 inch of level.

How much does a foundation elevation survey cost?

It is usually part of a foundation inspection. Angi's 2026 national average for a foundation inspection is $600 (most pay $300–$3,000), and HomeGuide lists a structural engineer foundation inspection at $300–$750.

How do I know if the foundation is still moving?

Compare two surveys taken from the same reference point. The FPA homebuyer guide says a second survey six to twelve months later can show whether movement is ongoing.

Keep reading

Sources cited on this page: Angi, How Much Does Foundation Repair Cost? (updated Oct 26, 2026); Angi, How Much Does Pier and Beam Foundation Repair Cost? (updated Sep 18, 2026); Foundation Performance Association, FPA-SC-13-1: Guidelines for the Evaluation of Foundation Movement for Residential and Other Low-Rise Buildings (Rev. 1, Apr 11, 2015; PDF); Foundation Performance Association, FPA-SC-06-0: Homebuyers' Guide for Foundation Evaluation (Rev. 0, Oct 10, 2005; PDF); Angi, How Much Does a Foundation Inspection Cost? (2026 data, updated Oct 27, 2026); HomeGuide, How Much Does a Structural Engineer Cost? (Dec 1, 2025); Texas Master Naturalist, Alamo Area Chapter: Bexar County Soils; Texas Dept. of Licensing & Regulation, Technical Bulletin IHB TB 10-01 (Foundations on Expansive Soils). Cost figures are national, not San Antonio quotes.

LevelSATX Foundation Network connects San Antonio homeowners and commercial property owners with vetted, independent foundation repair contractors. We don't perform repairs; participating contractors pay us for referrals. Any company can apply to join the network.

Get your free foundation inspection

4 quick taps. Free, no obligation.

Question 1 of 4

What are you noticing?
What's the property's ZIP code?

What kind of property is it?

When would you like someone to look?
Where should your match reach you?

Referral service: LevelSATX Foundation Network connects San Antonio homeowners and commercial property owners with vetted, independent foundation repair contractors. We don't perform repairs; participating contractors pay us for referrals. Any company can apply to join the network. We share your request with one matched contractor. Details

Get my free inspection → Call (210) 796-7891